Protect-Proof LF 1K: 1-component solvent-free polyurethane

protect-proof LF 1K is a liquid, monolithic, solvent-free brush-applied waterproofing with a 100 % polyester fleece reinforcement. It is based on terminated polyether. The product is single-component, can be produced in various colours and is neither dangerous goods under GGVS nor a hazardous substance under EU Directive 1999/45/EC. Besides roof waterproofing, it can be used in a wide range of other structural waterproofing applications.

Clean the substrate, using a pressure washer if necessary. Oil, grease and wax must be removed, as must cement laitance, loose particles, release agents and cured membranes. Level out any unevenness beforehand. A primer is only needed on some special types of plastic. Apply with a roller or brush in one or two coats; the interval between two coats should not exceed 16 hours, otherwise the surface should be lightly roughened mechanically. Substrate requirement: moisture content below 10 %.

Typical for protect-proof LF 1K: balconies and terraces — the system is solvent-free and odourless, so it can also be used where smells would be a nuisance. Through the German general building test certificate (abP) it can additionally be used for waterproofing elements in contact with the ground. It is equally suitable for detail waterproofing and flat roof waterproofing wherever there is no time pressure. It is applied straight from the tub, without mixing components.

Waterproofing and protection of render and concrete, terraces and balconies, flat roofs, lightweight roofs made of metal or fibre cement, and asphalt membranes. The system adheres to concrete, fibre cement, mosaic, cement tiles, old but well-bonded acrylic and asphalt coatings, render, metal, brick, tiles, wood, bitumen and a wide range of roofing membranes such as PVC and EPDM, as well as to PU, XPS and EPS insulation. Not recommended on unsound substrates or for waterproofing swimming pool surfaces in contact with chemically treated water.

Skin formation in about half an hour, rainproof after around 30 minutes, drying at 20 °C and 50 % relative humidity in about two hours – lower humidity extends this. The membrane is free of bubbles and defects, vapour-permeable and has excellent weather and UV resistance. It remains elastic down to -30 °C and does not soften in heat. High tensile strength, high abrasion resistance, good chemical resistance, density approx. 1.35 g/cm³ to ISO 8962. Officially approved to ETAG 005; suitable as flat roof waterproofing with fleece reinforcement.

Available in 10.0 kg and 5.0 kg containers. Shelf life of at least 12 months in the original packaging in dry rooms at +4 to +32 °C. Use the material promptly once the container has been opened.

Dispose of contents and container in accordance with local, regional and national regulations. The safety data sheet points out that the product contains a HALS light stabiliser, which may cause allergic reactions.

 

protect-proof LF 1K container

 

Flat roof

 

Flat roof

 

Balcony

 

Terrace

 

Element in contact with the ground

Accessories and advice

Resins & reinforcement fleece

Matching reinforcement and accessories, tailored to each system.

View all accessories →

Application tools

Tools and accessories for applying the systems — available on request.

Custom solutions

Application-specific solutions, developed together with the contractor on site.

Questions about the right system?

A quick call or a short message is all it takes.