protect-proof 1K PU is a single-component polyurethane liquid membrane that cures quickly in all weather conditions. It is based on a moisture-activated accelerator and cures to a completely defect-free membrane with high tensile strength and good adhesion. The product is particularly suitable for the winter months and for climates with low humidity. Because the minimum consumption can be reached in a single coat, the waiting times and adhesion problems of multi-layer systems are avoided.
Clean the substrate with a pressure washer. Oil, grease and wax must be removed, as must cement laitance, loose particles, release agents and cured membranes. Level out any unevenness beforehand, then use the recommended primer. Mix at 300 rpm; for airless spraying add 5 to 10 % protect-proof thinner. Apply with a roller or brush in one or two coats; the interval between two coats should not exceed 48 hours. Substrate requirements: moisture content below 10 %, temperature 5 to 35 °C, relative humidity below 85 %. Consumption at least 1.5 to 1.8 kg/m², with 110 g fleece reinforcement to ETAG 005 approx. 2.5 to 3.0 kg/m². Clean tools first with paper towels, then with protect-proof cleaner; rollers cannot be reused.
Safety note: The product contains volatile, flammable solvents. Use only in well-ventilated areas, do not smoke and keep away from open flames. In enclosed areas work with fans and respiratory protection. Solvent vapours are heavier than air and collect at floor level.
Typical for protect-proof 1K PU: flat roof, balcony and terrace waterproofing, renovation layers on existing waterproofing and detail waterproofing. The system is solvent-based, making it the more economical alternative to solvent-free LF 1K.
Waterproofing and protection of plasterboard and cement boards, polyurethane insulating foam, verandas and balconies, roofs, lightweight roofs made of metal or fibre cement, and asphalt and EPDM membranes. The system adheres to concrete, fibre cement, mosaic, cement tiles, old but well-bonded acrylic and asphalt coatings, and wood. Not recommended on unsound substrates or for waterproofing swimming pool surfaces in contact with chemically treated water. In dark shades, outdoor use requires a top coat of pigmented protect-proof Colour Coat 2K PU.
Skin formation in two hours, tack-free after two to three hours, recoatable after 6 to 48 hours. Service temperature -40 to +80 °C, short-term shock temperature up to 200 °C. Hardness 70 Shore A, tensile strength 65 kg/cm² (6.5 N/mm²), elongation over 400 %. Passed the QUV accelerated weathering test to ASTM G53 over 2,000 hours. The coating is water-vapour-permeable and has good chemical resistance. Suitable as a flat roof coating with fleece reinforcement; proof of approval is available on request. The product meets the EU EOTA guideline.
Available in 1 kg, 6 kg, 15 kg and 25 kg containers. Shelf life of at least 12 months in the original packaging in dry rooms at +5 to +25 °C. Use the material promptly once the container has been opened.
Dispose of contents and container safely in accordance with local and national regulations and take them to a hazardous waste collection point. Handle empty containers with care – residual vapours are flammable. Avoid release into the environment.
protect-proof 1K PU container
Roof area
Lightweight metal roof
Balcony
Terrace
A quick call or a short message is all it takes.